(1) Do not pull the lead wire or use it as a tool for installation or transportation. It may cause disconnection.
(2) Please do not use nails or screws because it will cause short-circuit when installing the sensing edge. When fixed, the specified adhesive, double-sided tape,We recommend using channels and joint construction.

(1) Use within the temperature range specified in the specifications.
(2) Use in flooded condition is dangerous. (Waterproof, spinning depends on the product.)
(3) The switch is always off type. Avoid putting it in the ON state for a long time with heavy load.

The warranty period of the delivered product will be one year after delivery. During the warranty period, if the fault occurs due to the responsibility of the company, the defective product will be replaced or repaired free of charge. However, please note that the following cases will be excluded from the warranty.

(1) In case of use in other than the conditions of use such as catalog, specification, etc.
(2) If there is a requirement for users to modify the supplied product

(3) When the cause of the trouble is other than the delivered product
(4) Failure to observe the handling precautions Note: Warranty is a guarantee for the delivered product and does not include any other damage caused

There are five ways to discharge the lead wire. Specify a discharge method when estimating (4-wire safety device).

EE: To both sides
OE: One side only
RH: Both ends (right) End of Angle Channel
LH: Both ends (left) Angle channel end
BOT: Floor surface
※ If you would like a special method, please feel free to contact us.

We will introduce the detection edge that will be used for stage equipment and unmanned buggy car buggies.
It is a curved and curved sensing edge that allows "bend" on the common sense edge.
(1) Horizontal curve sensing edge switch
Side bending possible with a radius of 760mm or more
• There is also a bend in the channel (plastic channels only)
• Use: Hospital facilities for special stage devices, gymnasium facilities, etc.