가교엔지니어링

Product
Product

Customer Center: I will always listen to the customer's voice.; +82.2.2618.5228; FAX : +82.2.2618.5226; E-mail : kakyo9@kakyoeng.com

Tape switch

> Product > Tape switch

작성일 : 19-05-10 10:42

[Tape switches?] 테이프 스위치란?

글쓴이 : 가교엔지니…

1.What is a tape switch?

Tape switches are made to have electrical contacts with length and width. You can freely change the length, cut it to the required length, and use it as a switch function immediately after terminal processing with wire.

1-1.Characteristic

1) It has a long life span.
Contact resistance is very low, less than 50mΩ. Therefore, even if the ON / OFF is repeated,You can use it for a long time.
(2) It is safe even if it is long.
It is possible to operate at low power (small power), conductor resistance is small even at long distance,Can be used.
(3) The withstand voltage is high.
1000V AC for 2 minutes. Despite the narrow conductors, it maintains high insulation.(Except the 180 type).
(4) Good response.
It is suitable for transistors and IC drive circuits that have good response and response speed.

1-2.principle

A common switch has a length and width. The pushed portion becomes the contact point of the reverse snap action,ON state.
Press the bead (protrusion) at the top to turn the switch ON.

1-3.rescue

Between the upper phosphor bronze plate and the thick copper plated bottom spring steel plateBoth ends of the conductors are insulated with a Myra Polystar filmSpecial plastic (polyvinyl chloride plastic) with a high corrosion resistance around the periphery has been subjected to extrusion coating.Cutting to a required length and terminating with a wire, a switch with high water resistanceYou can create

Sectional structure of tape switch
1. Yellow plastic exterior
2. Nylon fiber
3. Top insulation (mummy)
4. Upper conductive plate (phosphor bronze)
5.Middle and lower insulation material (mummy)
6. Lower conductive plate (copper-plated steel plate)

1-4.The contact responds with a 4-wire type.

2. The switch is usually a switch, but it also supports fail-safe detection of disconnection.

Please use it in such a place.
Tape switches and mat switches are used for nursing care and security measures at homes and facilities, safety measures at workplaces such as factories.

Nursing welfare at home / facility

Control of self-service wardrobe
Put the mat down on the mat switch
It's possible.

Matt Switch
When you sit in a wheelchair, the switch turns ON.

Bed and floor detection mat
You can install it secretly with the rope detection mat.

Crime prevention and safety measures at home and various stores

Outer bound control
Prevent intruders by installing in the wall.

Security switch
It is installed under the counter.

Security safe
The switch will be on at the moment the safe is heard

Safety measures in various workplaces

ATM The machine will work if you stand in front of the ATM	Shutter Keep your feet at a standstill.	Emergency stop of work robot Once inside the zone, the robot will stop working.
Bumper Switch It is used for unmanned return vehicle at the factory.	Under the carpet It is used under carpet and stairs as a sensor of visitor.	sensing edge switch It is used for semiconductor factories, etc.

In addition,

Prevent accidents by attaching to a bus hatch.	Load switch Detects the vehicle passing through.	Automatic door It is installed in the automatic door and prevents accidents such as being caught in the door.
Lift stop mat Stop the elevator while someone is in the parking lot.	Instrumentation touch panel Measure the touch plate installed in a swimming pool.

ProductProduct